During the configuration phase, various errors or messages can be displayed in ibaPDA, such as
"Configured module not found: Module No <X> (Slot <X-1>) not connected"
The ibaPDA configuration does not match the actual configuration of the system. A difference has been detected at position "X". The difference detected first is always displayed. If there are several differences between the ibaPDA configuration and the system, only the first one detected will be displayed.
Note |
|
|---|---|
 |
Please note that the ibaW-750 device only reads out the terminal configuration once during start-up. All subsequent changes during terminal removal can only be recognized by the ibaW-750 device when it is restarted. However, a terminal modification at runtime also causes a K-bus error. The system should always be restarted after such an error. See the note in chapter K-bus error. |