Planning the signal to measuring location assignment

For a comprehensible configuration, it is advisable to define the data relevant to quality for the ibaQDR store and list it in a table.

You can then add the signal name, unit and, if applicable, the measuring channel number, and also note the assigned measuring locations and profiles.

Tip

In addition to the measured quality data, you should also store the tracking signals. This helps to verify easily the length mapping of ibaQDR in ibaAnalyzer.

Table Example signal table
ID	Signal name	Unit	Measuring location	Profile
[0:0]	Speed	m/s	Uncoiler 1	1m + As is
...	Strip thickness	mm	Thickness gauge 1	1m + As is
...	Speed	m/s	Uncoiler 2	1m + As is
...	Strip thickness	mm	Thickness gauge 2	1m + As is
...	Entry looper strip tension	kN	Bridle roll 1	1m + As is
...	Furnace temperature	°C	Heating zone	1m + As is
...	Galvanizing bath temperature	°C	Galvanizing bath	1m + As is
...	Galvanizing layer thickness	g/m²	Air knife	1m + As is
...	Rolling force	kN	Skin pass mill	1m + As is
...	...	...	...	...