In the General tab, you can configure the following settings for the HiPAC Request module with reflective memory.
Basic, Module Layout
The basic settings and the module layout under Basic are identical to UDP, see chapter General module settings.
Advanced
Asynchronous mode
If you enable asynchronous mode (True), then the data will be copied from the card memory outside the interrupt service routine (ISR). This mode can be used to measure large amounts of data with a slower acquisition rate than the interrupt.
If you disable the asynchronous mode, then ibaPDA attempts to copy the data within the ISR. Data loss occurs if the ISR does not have enough time for the amount of data.
Request connection
Data offset on RM
This is the initial offset in the reflective memory where the data for this module is written.
The value is only for informational purposes and cannot be changed.