Installing the card

Proceed as follows to install the card.

Note
	In order to take advantage of the plug and play function, be sure that ibaPDA V6.21.0 (V6.23.1 for PCIe), respectively ibaLogic has been installed before inserting the card. Otherwise the card will not be automatically recognized by Windows.

1. Shut down the computer.

2. Switch off the power supply of the computer.

3. Unplug the mains power line.

4. Open the computer on the side where you can reach the PCI(e) slots.

5. Carefully remove the card from its packaging.

6. Hold the card by the front panel and the top rear corner. Do not touch the contacts.

7. Carefully insert the card into a free PCI(e) slot.

   Tip
   	To avoid damaging the card, press on the top of the front plate and on the top edge of the circuit board when inserting the card. Do not press on the plugs along the top edge of the card. They might brake off.

8. Attach the card to the housing of the computer.

   If you install more than one card, connect them with a flat ribbon cable (sync cable).

9. Close the computer.

10. Insert the mains plug into the earthed socket.

11. Switch on the power supply of the computer.

12. Start the computer.