Use the S10 button to reset all settings (network parameters, passwords, signal configuration) to the factory settings.
-
Switch off the device.
-
Switch on the device while holding down button S10.
-
Press and hold the button until the green “Run” LED of the operating status indicator starts flashing rapidly.
-
Release the button again.
When the green “Run” LED stops flashing rapidly, the factory settings have been applied. The device is ready for immediate use and does not need to be switched off and on again.
Note |
|
|---|---|
 |
The device must not be switched off during the process. |
For detailed notes on the factory settings, please see chapters Ethernet interface (network) and Accessing the web interface (password).