Description

ibaLogic TCP is a special connection between ibaLogic and ibaPDA. Data can be transmitted directly from the ibaLogic application program to ibaPDA for the measurement.

This interface is only available if the respective license is valid. Up to 64 connections or modules respectively are supported.
Interface configuration

Port number

Default setting: 40000. This port number can be changed but must be the same in both ibaLogic and ibaPDA systems in order to establish a connection.

<Reset port to default>

Use this button to reset the port to the default port number.

Allow ports through firewall

When installing ibaPDA, the default port numbers of the used protocols are automatically entered in the firewall. If you change the port number or enable the interface subsequently, you have to enable this port in the firewall with this button.

Network interfaces

Using this drop-down list, you can select which network adapters on your computer are used for this interface. The sockets will be opened for communication only on the selected network adapters. In case a network adapter has multiple IP addresses configured, a socket will be opened for all of these IP addresses. At least one network adapter should be selected to get the interface configuration validated. If you select None, an error message will be displayed when validating the I/O configuration. By default, the option All is selected.
Connection table

Address

This is the IP address of the source computer from which ibaPDA receives data.

Module index

The module index indicates which module number in ibaPDA should be assigned to this connection. The module index must be configured in the source system, e.g. ABB, ibaLogic. This module index must correspond to the entry in the field, Module index, in the corresponding module in the I/O Manager (module level, General tab). If necessary, adjust the module index on the source page or in ibaPDA.
Available modules

  • ibaLogic
Product name

ibaPDA-Interface-ibaLogic-TCP (Art. no. 31.001015)