Swap mode

The only parameter to be adjusted in this dialog is the swap mode. The drop-down list offers several options of high- and lowbyte swapping (Endian control). Which mode is the right one depends on the connected system. Changes in this setting have immediate effect unless acquisition is running. If the acquisition is running at this time, the changing applies only after pressing <OK>.

Error indicators

Information about errors, which are detected by the card driver.

Number of nodes

Information about number of connected nodes in the network. Automatically detected by the interface board.

PCI Info

In the PCI Info area of the dialog, you find the following information:

  • Slot Number Number of the PCI slot where the card is plugged in.

  • Bus Number PCI bus connected with this slot

  • IO Address Start address of the I/O address range of the card (hex)

  • Mem. Address Start address of the memory region (hex)

  • IO Length Size of the I/O address range (hex), free / reserved

  • Memory Length Size of the memory region (hex), free / reserved

  • Manufacturer Name of the board manufacturer

  • Board ID: PCI board ID (hex); also listed in the PCI table when system is booting.