Basics
For notes on the general module settings see General module settings.
Note |
|
|---|---|
 |
You may add an ibaNet750 module either on the input side (Inputs tab) or on the output side (Outputs tab) and add input terminals as well as output terminals. The module number of the ibaNet750 module will always be the same on both sides. Depending on the connection mode of the module (see description below), the module is available on just one or both sides. |
ibaNet750
Address mode
The address mode setting must comply with the switch setting (S1) on the device.
|
Mode |
Switch positions on device |
Addresses |
Number of analog and digital signals |
|---|---|---|---|
|
1 |
1– 8 |
1– 8 |
8/8 |
|
2 |
C – F |
1 - 2, 3 - 4, 5 - 6, 7 - 8 |
16/16 |
|
4 |
A, B |
1 - 4, 5 - 8 |
32/32 |
ECO mode
The ECO mode setting (TRUE or FALSE) must comply with the switch (S2) position on the device.
Connection mode
With the connection mode setting, you can control the mapping of the input and output fiber optical links of an ibaFOB card to an ibaNet750-BM device.
|
Mode |
Display |
Comment |
|---|---|---|
|
I |
Inputs |
Module is only visible in the Inputs tab of the I/O manager, even with output terminals, if configured. Module is not visible in the Outputs tab. FO output link is not mapped to ibaNet750-BM device. |
|
O |
Outputs |
Module is only visible in the Outputs tab of the I/O manager, even with input terminals, if configured. Module is not visible in the Inputs tab. FO input link is not mapped to ibaNet750-BM device. |
|
IO |
Inputs and Outputs |
The module will be visible in the Inputs and Outputs tabs. FO input and output links are mapped to the ibaNet750-BM device. |