You can use the ibaNet-E interface to establish a connection to an ibaNet-E-compatible device.
If you use ibaPDA on a PC, the connection is established over the network adapter of the computer or over a special ibaNet-E network adapter (ibaM-2E). In this case you can connect to devices as follows:
-
ibaW-750 + output terminals of the WAGO I/O-System 750
-
ibaM-COM + output modules of the ibaMAQS system
If you use ibaPDA on an ibaM-DAQ, then you configure the ibaM-DAQ device itself with its own outputs as well as attached modules of the ibaMAQS system on the IO bus (internal ibaNet-E). Additionally, several modules are available for selection, which can be configured as output modules:
-
ibaW-750 + output terminals of the WAGO I/O-System 750
-
ibaM-COM + output modules of the ibaMAQS system or + ibaM-FOB-2io with ibaPADU-/ibaBM devices with output modules
The configuration of outputs for ibaW-750 follows the same way like for ibaNet-750-BM.
When configuring the combination of ibaM-COM + ibaM-FOB-2io + ibaPADU-/ibaBM devices with output modules, the rules and settings of the connected devices apply.